Page 1 of 1
[Twinsen] [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Sun Dec 17, 2017 8:36 pm
by Nexela
Tested with no mods
Express UG was used for this.
Blueprint one end of an underground, place the blueprint, rotate the blueprint and place the other end to form a complete underground, after building the direction gets reversed. .
Re: [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Sun Dec 17, 2017 10:02 pm
by impetus maximus
you are placing an entrance twice. when you place the second one, of course the first is going to become an exit.
Re: [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Mon Dec 18, 2017 5:39 pm
by Twinsen
When placing the second underground belt it follows the direction of the one it connects with.
The animation even shows this.
Re: [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Sun Dec 31, 2017 10:41 pm
by vicarion
Came to report this same issue.
Using a blueprint of only an entrance. After placing the first entrance, and then rotating the blueprint to place an exit. The animation shows that it will obey the first belt when hovering, but as soon as you click it reverses.
Re: [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Wed Jan 03, 2018 3:17 pm
by Twinsen
Ah, I retested this and it is indeed incorrect.
Re: [Twinsen] [0,16.4] Underground Belt BP's cause direction to reverse
Posted: Fri Jan 05, 2018 11:18 am
by Twinsen
Fixed in Version: 0.16.15.