Page 1 of 1

[Twinsen][0.16.3] Placing circuit wire blueprint over train signals does not work

Posted: Sat Dec 16, 2017 6:11 am
by Xeteth
I believe there was some discussion about how this should work in the lead up to 0.16 and I'm not 100% sure on the outcome, however I have found an inconsistency with wiring between entities on blueprint.

If you have two entities that are not connected with red/green wire (such as two inserters) then you run a blueprint over it with a wire connection present it will result in the two entities being wired together.

This seems to work for all entities except for rail and/or chain signals.

This picture below should help demonstrate what I'm saying.
PIC

Re: [Twinsen][0.16.3] Placing circuit wire blueprint over train signals does not work

Posted: Mon Dec 18, 2017 1:17 pm
by Twinsen
Thanks for the detailed report.

Fixed in Version: 0.16.6 for both signals and chain signals.