Page 1 of 1
[0.10.6][slpwnd] toolbar filter removed but image stays
Posted: Wed Aug 06, 2014 8:38 pm
by arl85
as already noted
here when you remove a filter on toolbar image of (former) filtered item is retained.
I'm quite sure it's a recent bug, because I don't remember seeing it in last versions
Re: [0.10.6] toolbar filter removed but image not cleared
Posted: Thu Aug 07, 2014 1:02 pm
by slpwnd
I couldn't reproduce this. Removing the filter clears the image as expected. However, it could be related to this though (
https://forums.factorio.com/forum/vie ... f=7&t=5130). I use alt + left / alt + right click to set / clear the filter (because I have only two mouse buttons
).
Re: [0.10.6] toolbar filter removed but image not cleared
Posted: Thu Aug 07, 2014 1:08 pm
by JLBShecky
I have seen this happen once, but only once on 10.3 with a modded item, but it has never happened again, and come to think of it I have never tried to set a modded item filter on the toolbar and clear it since then.
[Edit]
Ok I think I figured out what caused it in my case. It seems that if you have a filter set and you flip the top and bottom rows of the toobelt then the filter icons will not update till you flip them again. You are able to put the new item into the slot but they will display the old item and not the new one. Also as depicted below, if you clear a slot filter in it's bugged state, it will retain the filter icon until you flip the rows again and then it will return to working normally.
Re: [0.10.6] toolbar filter removed but image not cleared
Posted: Thu Aug 07, 2014 5:35 pm
by arl85
slpwnd wrote:I couldn't reproduce this. Removing the filter clears the image as expected. However, it could be related to this though (
https://forums.factorio.com/forum/vie ... f=7&t=5130). I use alt + left / alt + right click to set / clear the filter (because I have only two mouse buttons
).
Yes, I think it's related; I'm using mouse wheel to remove filter
Re: [0.10.6][slpwnd] toolbar filter removed but image stays
Posted: Fri Aug 08, 2014 7:32 am
by slpwnd
JLBShecky wrote:
Ok I think I figured out what caused it in my case. It seems that if you have a filter set and you flip the top and bottom rows of the toobelt then the filter icons will not update till you flip them again. You are able to put the new item into the slot but they will display the old item and not the new one. Also as depicted below, if you clear a slot filter in it's bugged state, it will retain the filter icon until you flip the rows again and then it will return to working normally.
Thanks for the precise description. This was indeed the cause of an error. It will be fixed in the 0.10.7.
arl85 wrote:Yes, I think it's related; I'm using mouse wheel to remove filter
Interesting coincidence
Anyway this will be fixed as well in the 0.10.7.