[Rseding91] [0.15.x] Deconstruction planner summary goes off screen edge
Posted: Tue Jun 27, 2017 5:06 am
Playing fullscreen on a 1080p display, if I zoom all the way out and use the deconstruction planner to mark large areas from top right to bottom left (like the entire smelting setup for one of my circuit factories, tonight), if the cursor gets too close to the left edge of the screen the summary of items that will be deconstructed goes out of view.
I tried several different ways of taking a screenshot of this but had no success—either the keybinding I set in the OS to take a screenshot interrupted the deconstruction planner, or caused the selection to complete and robots to start removing entities. If needed I will try a more brute-force approach, but I think the problem is evident enough if one simply uses any deconstruction planner to select most of the visible area from top right to bottom left.
When selecting from left to right, this is not an issue. It only manifests when selecting from right to left, because the entity counts are hardcoded to appear on the left side of the cursor.
I tried several different ways of taking a screenshot of this but had no success—either the keybinding I set in the OS to take a screenshot interrupted the deconstruction planner, or caused the selection to complete and robots to start removing entities. If needed I will try a more brute-force approach, but I think the problem is evident enough if one simply uses any deconstruction planner to select most of the visible area from top right to bottom left.
When selecting from left to right, this is not an issue. It only manifests when selecting from right to left, because the entity counts are hardcoded to appear on the left side of the cursor.