Page 1 of 1
[Posila] Blueprinted pumps at train station don't work
Posted: Mon Jun 05, 2017 1:21 pm
by steinio
Hi,
i blueprinted some train stations and had the issue that the pumps don't started pumping until i rotated them twice.
Could it be possible, that the pump don't get registered as train station pump if it is blueprinted?
Greetings, steinio.
Re: Blueprinted pumps at train station doen't work
Posted: Mon Jun 05, 2017 1:33 pm
by Shokubai
Was the train already in station?
Re: Blueprinted pumps at train station doen't work
Posted: Mon Jun 05, 2017 2:42 pm
by steinio
Shokubai wrote:Was the train already in station?
Yes also in automatic mode.
Need to test further... but i swear it was there.
Save attached. Mods here (320mb):
https://houseofsteinert.hopto.org/mods.zip
The train arrives at the station and the pumps don't work.
Rotate them twice and they start working.
At the unloading station all is fine.
Greetings, steinio.
Re: [Posila] Blueprinted pumps at train station don't work
Posted: Wed Jun 28, 2017 12:48 pm
by posila
Thanks for the report.
I wasn't able to reproduce it myself in vanila, but when I loaded your save, pumps really didn't connect. I tested the save in the latest master and they did connect there, so it seems the issue was resolved by other changes we did to pumps.
Re: [Posila] Blueprinted pumps at train station don't work
Posted: Wed Jun 28, 2017 2:14 pm
by steinio
posila wrote:Thanks for the report.
I wasn't able to reproduce it myself in vanila, but when I loaded your save, pumps really didn't connect. I tested the save in the latest master and they did connect there, so it seems the issue was resolved by other changes we did to pumps.
Thank you.