Factorio Forums

Video: https://youtu.be/5Bj6XOEtlDs
Map save attached.

I've got a simple setup generating a 120BPM signal, one single note, one half note and one quarter note. I found that when I disconnected my quarter note speaker, the sound continued to play, but also had a duplicate sound playing. Adding the circuit wire back caused it to go back to playing a single sound, removing the wire made it duplicate again. Removing the speaker entirely causes the sound to stop as expected.

Not 100% a bug, since with the wire disconnected, the value of Q is 0. That means that every tick a sound was started(until the maximum polyphony was reached).

Nonetheless I made it so no sounds are made when no wire is connected.
Fixed in Version: 0.15.6.


Also your beat was calling for a snare so I added one

Twinsen!

Oh, I didn't think of that