Page 1 of 1
[boskid] Pumps can set filters using negative signals
Posted: Fri Dec 20, 2024 4:10 pm
by Tekbox
When you set filters for pumps using circuits they use any nonzero fluid signals, which while not a big deal in itself, tough slightly annoying to deal with, also is just plain inconsistent behavior considering that inserters only set their filter using positive signals, which is an actually useful trait.
Re: Pumps can set filters using negative signals
Posted: Fri Dec 20, 2024 4:58 pm
by Rseding91
Thanks for the report however this is not a bug. Assembling machines also do not care about what the value of a signal is.
Re: Pumps can set filters using negative signals
Posted: Fri Dec 20, 2024 6:17 pm
by Tekbox
Rseding91 wrote: ↑Fri Dec 20, 2024 4:58 pm
Thanks for the report however this is not a bug. Assembling machines also do not care about what the value of a signal is.
Then maybe more than just pumps need fixing in that regard.
Re: Pumps can set filters using negative signals
Posted: Fri Dec 20, 2024 6:21 pm
by InUniverse
Uh, no. Assembling machines
do ignore negative signals.
- 20241220131541_2.jpg (195.37 KiB) Viewed 715 times
And so do asteroid collectors and turrets, for that matter.
- 20241220131618_1.jpg (223.85 KiB) Viewed 715 times
- 20241220131513_1.jpg (214.97 KiB) Viewed 715 times
Re: [boskid] Pumps can set filters using negative signals
Posted: Sun Dec 29, 2024 1:10 pm
by boskid
Thanks for the report. Issue is now fixed for 2.0.29.