[Klonan] [2.0.14]Can't access Target section of the Interrupt GUI if too many conditions are set
Posted: Sun Nov 03, 2024 2:06 pm
In the case you fill too many conditions on a train interrupt, the target section of the GUI become inaccesible. Current work around is to just configure target before conditions
1-Put 20~ or so conditions in a interrupt conditions section
2-Targets sections of the same interrupt is no longer accesible.
Attached example
1-Put 20~ or so conditions in a interrupt conditions section
2-Targets sections of the same interrupt is no longer accesible.
Attached example