[Genhis][2.0.13] Undo module upgrade does not update GUI
Posted: Sat Nov 02, 2024 4:24 pm
When undoing a module upgrade from ghost to ghost, the GUI does not update
Step 1: Assembly Machine filled with ghost modules
Step 2: Upgrade the modules in remote view
Step 3: Click on the machine to open the GUI, and then Ctrl+Z downgrades the modules again, but does not update the GUI
Step 4: Closing and re-opening the GUI shows the correct ghost modules (no picture provided)
I provided a save file with the above setup, just in case. Thanks!
Step 1: Assembly Machine filled with ghost modules
- Step1.png (168.48 KiB) Viewed 1001 times
Step 2: Upgrade the modules in remote view
- Step2.png (656.76 KiB) Viewed 1001 times
Step 3: Click on the machine to open the GUI, and then Ctrl+Z downgrades the modules again, but does not update the GUI
- Step3.png (493.34 KiB) Viewed 1001 times
Step 4: Closing and re-opening the GUI shows the correct ghost modules (no picture provided)
I provided a save file with the above setup, just in case. Thanks!