[boskid][2.0.11] Constant combinator graphic doesn't show is active when sending signals
Posted: Sun Oct 27, 2024 1:52 pm
To reproduce:
1. place a constant combinator
2. wire the constant combinator to a pole
3. setup a signal in the constant combinator
The constant combinator graphic looks as if it was in the off state. Toggling the combinator off/on fixes it.
1. place a constant combinator
2. wire the constant combinator to a pole
3. setup a signal in the constant combinator
The constant combinator graphic looks as if it was in the off state. Toggling the combinator off/on fixes it.
- Screenshot_20241027_105140.png (100.75 KiB) Viewed 1024 times