[1.1.107] Conflict between logistics and circuit control behaviours for single tick
Posted: Sun Apr 14, 2024 3:24 pm
Noticed a conflict in control behaviours on inserters (at least): if using both the logistics and circuit connections, changes in settings to the circuit connection may override the logistics connection for one instant each time the circuit control setting is set to "None".
Below is a small reproduction blueprint where a Stack inserter is disabled by the logistics connection (enable if more than 60k upgrade planners in network) while also being connected to the circuit network. Each time the circuit connection is toggled from "Enable/disable" to "None" the inserter swings once before it "remembers" that it is still disabled by the logistics connection.
Expected behaviour is that the steel chest remains empty no matter how many times the settings are changed.
Possibly related to viewtopic.php?f=230&t=111736
Below is a small reproduction blueprint where a Stack inserter is disabled by the logistics connection (enable if more than 60k upgrade planners in network) while also being connected to the circuit network. Each time the circuit connection is toggled from "Enable/disable" to "None" the inserter swings once before it "remembers" that it is still disabled by the logistics connection.
Expected behaviour is that the steel chest remains empty no matter how many times the settings are changed.
Possibly related to viewtopic.php?f=230&t=111736
- conflict.png (169.56 KiB) Viewed 528 times